Magigoo Original lijmstift 50ml

Everything you need for optimal adhesion of 3D prints. Magigoo Original 50 ml is an easy-to-use 3D printing adhesive designed to address the issue of 'first layer not sticking'. Magigoo ensures strong adhesion on the heated bed. But the magic begins when your print is done: simply wait for the plate to cool down and remove your print with just a flick of the finger!

Furthermore, Magigoo helps prevent warping. Whether you're a professional or a beginner, with Magigoo Original 50 ml you are assured of good adhesion. It's nice to come back after a 30-hour print with a great result.

Watch the introduction video

Features of Magigoo Original 50 ml

• Lasts for more than 100 (average) prints
• Suitable for many types of filament: ABS, PLA, PETG, HIPS, ASA, TPU, and more!
• Easy to apply; applying Magigoo is child's play. Shake, press, apply. Spread only over an active print area. It is not necessary to cover the entire surface.
• Easy release; Magigoo is designed to release the 3D print once the heated bed has cooled down.
• Easy to clean; Magigoo is easily cleaned with water.
• No odor and non-toxic; Magigoo is safe to use.
• No additional tools needed
• Improved print finishing

Important note: The applicator has an active spring valve, which is activated when the applicator is pressed against the heated bed. Do not squeeze the bottle like a 'ketchup bottle', as this may cause the applicator to detach. The bottle should only be lightly squeezed when the tip is pressed against the bed.