Fiberlogy FiberFlex 30D Black

Fiberlogy FiberFlex 30D Black is flexible filament that is softer compared to the Fiberflex 40D. With a hardness of 30D on the Shore scale (comparable to, for example, a shoe sole), you can print very elastically. It is strongly recommended to print with a direct drive extruder and at low speed. It is highly suitable for prints that need to be able to bend and can be used for both amateur and professional applications. FiberFlex 30D filament can withstand lower temperatures, is wear-resistant, and has high impact resistance.

Fiberlogy is known for its premium quality filament that meets the highest quality standards and surpasses other manufacturers. By maintaining a diameter tolerance for flexible filament of 0.05 mm and a roundness tolerance of 0.03 mm, FiberFlex 30D sets itself apart from the rest, allowing you to get the best out of your 3D printer.

Applications

• Mechanics: gaskets, conveyor belts, hinge seals, enclosures, impact protection
• Gadgets: phone cases, pedometer or watch bands, VR goggles
• Household: bumpers, face masks, door stoppers, coasters, non-slip caps
• Toys: rubber figures, car tires, games, bumpers, airplanes
• Jewelry: bracelets, necklaces, rings, earrings

Tip: To make it easier to remove the print, it is recommended to heat the bed to 110°C

Shore hardness

Refer to the table below to compare the hardness of 30D. Also useful for comparison with other TPU filaments that use Shore A.