Fiberlogy FiberFlex 30D Graphite

Fiberlogy FiberFlex 30D Graphite (graphite gray) is a flexible filament that is softer compared to the Fiberflex 40D. With a hardness of 30D on the Shore scale (similar to, for example, a shoe sole), you can print very elastically. Printing with a direct drive extruder and at low speed is strongly recommended. Highly suitable for prints that need to be able to bend, and can be used for both amateur and professional applications. FiberFlex 30D filament can withstand lower temperatures well, is wear-resistant, and has high impact resistance.

Fiberlogy is known for its premium quality filament that meets the highest quality standards and goes beyond other manufacturers. By maintaining a diameter tolerance for flexible filament of 0.05 mm and a roundness tolerance of 0.03 mm, FiberFlex 30D sets itself apart from the rest and brings out the best in your 3D printer.

Applications

• Mechanics: gaskets, conveyor belts, hinge seals, housings, impact protection
• Gadgets: phone cases, pedometer or watch straps, VR glasses
• Household: bumpers, face masks, door stoppers, coasters, anti-slip caps
• Toys: rubber figures, car tires, games, bumpers, airplanes
• Jewelry: bracelets, necklaces, rings, earrings

Tip: To make it easier to remove the print, it is recommended to heat the bed to 110°C

Shore hardness

See the table below to compare the 30D hardness. Also useful for comparing with other TPU filaments that work with Shore A.