Fiberlogy FiberFlex 30D Gray

Fiberlogy FiberFlex 30D Gray is flexible filament that is softer compared to the Fiberflex 40D. With a hardness of 30D on the Shore scale (similar to, for example, a shoe sole), you can print very elastically. Printing with a direct drive extruder and at low speeds is highly recommended. It is very suitable for prints that need to be able to bend and can be used for both amateur and professional applications. FiberFlex 30D filament can withstand lower temperatures, is wear-resistant, and has high impact resistance.

Fiberlogy is known for its premium quality filament that meets the highest quality standards and goes above and beyond other manufacturers. By maintaining a diameter tolerance of 0.05 mm and a roundness tolerance of 0.03 mm for flexible filament, FiberFlex 30D distinguishes itself from the rest and allows you to get the best out of your 3D printer.

Applications

• Mechanics: gaskets, conveyor belts, hinge seals, enclosures, fall protection
• Gadgets: phone cases, pedometer or watch bands, VR glasses
• Household: bumpers, face masks, door stops, coasters, non-slip caps
• Toys: rubber figures, car tires, games, bumpers, airplanes
• Jewelry: bracelets, necklaces, rings, earrings

Tip: To make the print easier to remove, it is recommended to heat the bed to 110°C

Shore hardness

Refer to the table below to compare the hardness of 30D. Also useful for comparing with other TPU filaments that work with Shore A.